Version 25.3.9396

• Add the Zuora Connector
• Authenticate to Zuora
• Complete Your Connection
• More Information

You can use the Zuora connector from the CData Sync application to capture data from Zuora and move it to any supported destination. To do so, you need to add the connector, authenticate to the connector, and complete your connection.

Add the Zuora Connector

To enable Sync to use data from Zuora, you first must add the connector, as follows:

1. Open the Connections page of the Sync dashboard.

2. Click Add Connection to open the Select Connectors page.

3. Click the Sources tab and locate the Zuora row.

4. Click the Configure Connection icon at the end of that row to open the New Connection page. If the Configure Connection icon is not available, click the Download Connector icon to install the Zuora connector. For more information about installing new connectors, see Connections.

Authenticate to Zuora

After you add the connector, you need to set the required properties.

• Connection Name - Enter a connection name of your choice.

• OAuth Client Id - Enter the client Id that you were assigned when you registered your application with an OAuth authorization server.

• OAuth Client Secret - Enter the client secret that you were assigned when you registered your application with an OAuth authorization server.

Complete Your Connection

To complete your connection:

1. Specify the following properties:

   • Tenant - Select the tenant for your Zuora account. The default tenant is USProduction.

   • Zuora Service - Select the Zuora service that you want to use. The default service is AQuADataExport.

2. Define advanced connection settings on the Advanced tab. (In most cases, though, you should not need these settings.)

3. Click Create & Test to create your connection.

More Information

For more information about interactions between CData Sync and Zuora, see Zuora Connector for CData Sync.