Twilio
Version 25.3.9396
Version 25.3.9396
Twilio
You can use the Twilio connector from the CData Sync application to capture data from Twilio and move it to any supported destination. To do so, you need to add the connector, authenticate to the connector, and complete your connection.
Add the Twilio Connector
To enable Sync to use data from Twilio, you first must add the connector, as follows:
-
Open the Connections page of the Sync dashboard.
-
Click Add Connection to open the Select Connectors page.
-
Click the Sources tab and locate the Twilio row.
-
Click the Configure Connection icon at the end of that row to open the New Connection page. If the Configure Connection icon is not available, click the Download Connector icon to install the Twilio connector. For more information about installing new connectors, see Connections.
Authenticate to Twilio
After you add the connector, you need to set the required properties.
-
Connection Name - Enter a connection name of your choice.
-
Account SID - Enter the string identifier (SID) that you use to authenticate to your Twilio account.
CData Sync supports authenticating to Twilio in several ways. Select your authentication method below to proceed to the relevant section that contains the authentication details.
Auth Token
To connect with an authorization (auth) token, specify the following properties:
-
Auth Scheme - Select AuthToken.
-
Auth Token - Enter your auth token for your Twilio account.
API Key
To connect with an API key, specify the following properties:
-
Auth Scheme - Select APIKey.
-
API Key SID - Enter the API key SID for your Twilio account.
-
API Key Secret - Enter the API key secret for your Twilio account.
Complete Your Connection
To complete your connection:
-
Define advanced connection settings on the Advanced tab. (In most cases, though, you should not need these settings.)
-
Click Create & Test to create your connection.
More Information
For more information about interactions between CData Sync and Twilio, see Twilio Connector for CData Sync.