Version 25.3.9396

• Add the Smaregi Connector
• Authenticate to Smaregi
• Complete Your Connection
• More Information

You can use the Smaregi connector from the CData Sync application to capture data from Smaregi and move it to any supported destination. To do so, you need to add the connector, authenticate to the connector, and complete your connection.

Add the Smaregi Connector

To enable Sync to use data from Smaregi, you first must add the connector, as follows:

1. Open the Connections page of the Sync dashboard.

2. Click Add Connection to open the Select Connectors page.

3. Click the Sources tab and locate the Smaregi row.

4. Click the Configure Connection icon at the end of that row to open the New Connection page. If the Configure Connection icon is not available, click the Download Connector icon to install the Smaregi connector. For more information about installing new connectors, see Connections.

Authenticate to Smaregi

After you add the connector, you need to set the required properties.

• Connection Name - Enter a connection name of your choice.

• Access Token - Enter the access token for your Smaregi account. You can locate the access token in Smaregi by navigating to Configurations > System linkage > Smart API.

• Contract Id - Enter the contract identifier (Id) for your Smaregi account. You can locate the contract Id also by navigating to Configurations > System linkage > Smart API.

Complete Your Connection

To complete your connection:

1. Define advanced connection settings on the Advanced tab. (In most cases, though, you should not need these settings.)

2. Click Create & Test to create your connection.

More Information

For more information about interactions between CData Sync and Smaregi, see Smaregi Connector for CData Sync.