Oracle Eloqua

Version 24.2.8969

Oracle Eloqua

You can use the Oracle Eloqua connector from the CData Sync application to capture data from Oracle Eloqua and move it to any supported destination. To do so, you need to add the connector, authenticate to the connector, and complete your connection.

Add the Oracle Eloqua Connector

To enable Sync to use data from Oracle Eloqua, you first must add the connector, as follows:

  1. Open the Connections page of the Sync dashboard.

  2. Click Add Connection to open the Select Connectors page.

  3. Click the Sources tab and locate the Oracle Eloqua row.

  4. Click the Configure Connection icon at the end of that row to open the New Connection page. If the Configure Connection icon is not available, click the Download Connector icon to install the Oracle Eloqua connector. For more information about installing new connectors, see Connections.

Authenticate to Oracle Eloqua

After you add the connector, you need to set the required properties.

On the New Connection page, enter the connection name of your choice.

CData Sync supports authenticating to Oracle Eloqua via two methods. Select your authentication method below to proceed to the relevant section that contains the authentication details.


To connect with your user credentials, set the following properties:

  • Auth Scheme: Select Basic.

  • Company - Enter the name of the company for your Oracle Eloqua account.

  • User: Enter the username that you use to authenticate to your Oracle Eloqua account.

  • Password: Enter the password that you use to authenticate to your Oracle Eloqua account.


CData Sync provides an embedded OAuth application with which to connect. To use the application, select OAuth for Auth Scheme. No additional properties are required.

Complete Your Connection

To complete your connection:

  1. Define advanced connection settings on the Advanced tab. (In most cases, though, you should not need these settings.)

  2. If you authenticate with OAuth, click Connect to Oracle Eloqua to connect to your Oracle Eloqua account.

  3. Click Create & Test to create your connection.

More Information

For more information about interactions between CData Sync and Oracle Eloqua, see Oracle Eloqua Connector for CData Sync.