Version 24.3.9120

• Add the EnterpriseDB Connector
• Authenticate to EnterpriseDB
• Complete Your Connection
• More Information

You can use the EnterpriseDB connector from the CData Sync application to capture data from EnterpriseDB and move it to any supported destination. To do so, you need to add the connector, authenticate to the connector, and complete your connection.

Add the EnterpriseDB Connector

To enable Sync to use data from EnterpriseDB, you first must add the connector, as follows:

1. Open the Connections page of the Sync dashboard.

2. Click Add Connection to open the Select Connectors page.

3. Click the Sources tab and locate the EnterpriseDB row.

4. Click the Configure Connection icon at the end of that row to open the New Connection page. If the Configure Connection icon is not available, click the Download Connector icon to install the EnterpriseDB connector. For more information about installing new connectors, see Connections.

Authenticate to EnterpriseDB

After you add the connector, you need to set the required properties.

• Connection Name - Enter a connection name of your choice.

• User - Enter the username that you use to authenticate to your EnterpriseDB account.

• Password - Enter the password that you use to authenticate to your EnterpriseDB account.

Complete Your Connection

To complete your connection:

1. Specify the following properties:

   • Server - Enter the host name or IP address of the server that hosts the EnterpriseDB database. The default server is localhost.

   • Database - Enter the name of your EnterpriseDB database.

   • Port - Enter the port number of the EnterpriseDB server. The default port is 5444.

2. Define advanced connection settings on the Advanced tab. (In most cases, though, you should not need these settings.)

3. Click Create & Test to create your connection.

More Information

For more information about interactions between CData Sync and EnterpriseDB, see EnterpriseDB Connector for CData Sync.