Version 24.3.9120

• Add the Garoon Connector
• Authenticate to Garoon
• Complete Your Connection
• More Information

You can use the Garoon connector from the CData Sync application to capture data from Garoon and move it to any supported destination. To do so, you need to add the connector, authenticate to the connector, and complete your connection.

Add the Garoon Connector

To enable Sync to use data from Garoon, you first must add the connector, as follows:

1. Open the Connections page of the Sync dashboard.

2. Click Add Connection to open the Select Connectors page.

3. Click the Sources tab and locate the Garoon row.

4. Click the Configure Connection icon at the end of that row to open the New Connection page. If the Configure Connection icon is not available, click the Download Connector icon to install the Garoon connector. For more information about installing new connectors, see Connections.

Authenticate to Garoon

After you add the connector, you need to set the required properties.

• Connection Name - Enter a connection name of your choice.

• URL - Enter the URL for your Garoon account.

• User - Enter the username that you use to authenticate to your Garoon account.

• Password - Enter the password that you use to authenticate to your Garoon account.

Complete Your Connection

To complete your connection:

1. Specify the following properties:

   • Basic Auth User - Enter the additional username that is required for domains that use basic authentication.

   • Basic Auth Password - Enter the additional password that is required for domains that use basic authentication.

2. Define advanced connection settings on the Advanced tab. (In most cases, though, you should not need these settings.)

3. Click Create & Test to create your connection.

More Information

For more information about interactions between CData Sync and Garoon, see Garoon Connector for CData Sync.