Sage 200
Version 24.3.9110
Version 24.3.9110
Sage 200
You can use the Sage 200 connector from the CData Sync application to capture data from Sage 200 and move it to any supported destination. To do so, you need to add the connector, authenticate to the connector, and complete your connection.
Add the Sage 200 Connector
To enable Sync to use data from Sage 200, you first must add the connector, as follows:
-
Open the Connections page of the Sync dashboard.
-
Click Add Connection to open the Select Connectors page.
-
Click the Sources tab and locate the Sage 200 row.
-
Click the Configure Connection icon at the end of that row to open the New Connection page. If the Configure Connection icon is not available, click the Download Connector icon to install the Sage 200 connector. For more information about installing new connectors, see Connections.
Authenticate to Sage 200
After you add the connector, you need to set the required properties.
-
Connection Name - Enter a connection name of your choice.
-
Subscription Key - Enter your subscription key. To locate your key:
-
Register for access to the Sage API.
-
Log into Sage 200 and navigate to your profile. The subscription key is available in the profile.
-
-
Schema - Select the schema for your edition of Sage 200. The default schema is Standard UK.
Complete Your Connection
To complete your connection:
-
Define advanced connection settings on the Advanced tab. (In most cases, though, you should not need these settings.)
-
Click Connect to Sage 200 to connect to your Sage 200 account.
-
Click Create & Test to create your connection.
More Information
For more information about interactions between CData Sync and Sage 200, see Sage 200 Connector for CData Sync.