Version 26.2.9623

• Add the Square Connector
• Authenticate to Square
• Complete Your Connection
• More Information

You can use the Square connector from the CData Sync application to capture data from Square and move it to any supported destination. To do so, you need to add the connector, authenticate to the connector, and complete your connection.

Add the Square Connector

To enable Sync to use data from Square, you first must add the connector, as follows:

1. Open the Connections page of the Sync dashboard.

2. Click Add Connection to open the Select Connectors page.

3. Click the Sources tab and locate the Square row.

4. Click the Configure Connection icon at the end of that row to open the New Connection page. This action opens the Add Connection dialog box.

   Note: If the Configure Connection icon is not available, click the Download Connector icon to install the Square connector.

5. Enter a name for your connection in the Add Connection dialog box.

6. Click Add to open the Settings tab for your connector.

For more information about installing new connectors, see Connections.

Authenticate to Square

After you add the connector, you need to set the required properties.

Complete Your Connection

To complete your connection:

1. Specify the following properties:

   • (Optional) Location Id: Enter the Id for your business location.

   • Use Sandbox: Select whether you want to enable the sandbox. By default, the Enable checkbox is not selected.

   • Schema: - Select the schema that you want to use. The default schema is v1.

2. Define advanced connection settings on the Advanced tab. (In most cases, though, you should not need these settings.)

3. Click Connect to Square to connect to your Square account.

4. Click Create & Test to create your connection.

More Information

For more information about interactions between CData Sync and Square, see Square Connector for CData Sync.