Version 26.2.9623

• Add the Cvent Connector
• Authenticate to Cvent
• Complete Your Connection
• More Information

You can use the Cvent connector from the CData Sync application to capture data from Cvent and move it to any supported destination. To do so, you need to add the connector, authenticate to the connector, and complete your connection.

Add the Cvent Connector

To enable Sync to use data from Cvent, you first must add the connector, as follows:

1. Open the Connections page of the Sync dashboard.

2. Click Add Connection to open the Select Connectors page.

3. Click the Sources tab and locate the Cvent row.

4. Click the Configure Connection icon at the end of that row to open the New Connection page. This action opens the Add Connection dialog box.

   Note: If the Configure Connection icon is not available, click the Download Connector icon to install the Cvent connector.

5. Enter a name for your connection in the Add Connection dialog box.

6. Click Add to open the Settings tab for your connector.

For more information about installing new connectors, see Connections.

Authenticate to Cvent

After you add the connector, you need to set the required properties.

• OAuth Client Id: Enter the client Id that you were assigned when you registered your application with an OAuth authorization server.

• OAuth Client Secret: Enter the client secret that you were assigned when you registered your application with an OAuth authorization server.

Complete Your Connection

To complete your connection:

1. Specify the following properties:

   • (Optional) For Scope, specify the scope of your access to the Cvent application.

2. Define advanced connection settings on the Advanced tab. (In most cases, though, you should not need these settings.)

3. Click Create & Test to create your connection.

More Information

For more information about interactions between CData Sync and Cvent, see Cvent Connector for CData Sync.