Search

FHIR

Version 26.2.9623

FHIR

You can use the FHIR connector from the CData Sync application to capture data from FHIR and move it to any supported destination. To do so, you need to add the connector, authenticate to the connector, and complete your connection.

Add the FHIR Connector

To enable Sync to use data from FHIR, you first must add the connector, as follows:

  1. Open the Connections page of the Sync dashboard.

  2. Click Add Connection to open the Select Connectors page.

  3. Click the Sources tab and locate the FHIR row.

  4. Click the Configure Connection icon at the end of that row to open the New Connection page. This action opens the Add Connection dialog box.

    Note: If the Configure Connection icon is not available, click the Download Connector icon to install the FHIR connector.

  5. Enter a name for your connection in the Add Connection dialog box.

  6. Click Add to open the Settings tab for your connector.

For more information about installing new connectors, see Connections.

Authenticate to FHIR

After you add the connector, you need to set the required properties.

  • URL: Enter the Service Base URL for your FHIR server.

  • Connection Type: Select the type of connection that you want to use. The default type is Generic.

  • Auth Scheme: Select the authentication scheme that you want to use. The default scheme is GenericOAuth. For this setting, specify the following values:

    • OAuth Client Id: Enter the client Id that you were assigned when you registered your application with an OAuth authorization server.

    • OAuth Client Secret: Enter the client secret that you were assigned when you registered your application with an OAuth authorization server.

    • OAuth Authorization URL: Enter the authorization URL for the OAuth service.

    • OAuth Access Token URL: Enter the URL from which to retrieve the OAuth access token.

    • OAuth Refresh Token URL: Enter the URL from which to refresh the OAuth token.

Complete Your Connection

To complete your connection:

  1. Define advanced connection settings on the Advanced tab. (In most cases, though, you should not need these settings.)

  2. Click Create & Test to create your connection.

More Information

For more information about interactions between CData Sync and FHIR, see FHIR Connector for CData Sync.