ODBC Driver for GraphQL

Build 23.0.8839

Executing Queries

This section describes how to execute queries using MySQL remoting from any tool that can connect to MySQL.

When executing queries, use a two-part name, in the format:

[<Schema Name>].[<Table Name>] 
  • Schema Name is the name of the system schema or user-defined schema. (This is normally the service name.)
  • Table Name is the name of the table you are copying data from.

SELECT Statements

To create new records:
SELECT * FROM [GraphQL].[Users] WHERE UserLogin = 'mojombo' 
Note: MySQL treats identifiers as case-insensitive, even if the data source supports case-sensitive identifiers. This can be a problem when the database contains multiple tables of the same name in a single schema, because when using MySQL it is not possible to query tables of the same name that only vary by upper or lower case-sensitive (for example, a schema with one table named Account, and a second table named ACCOUNT).


To insert, update, or delete a single row of data against a writeable database, use the two-part name. For example:
INSERT INTO [GraphQL].[Users] (UserLogin) VALUES ('mojombo'); 

Bulk Operations

To perform bulk operations, use syntax similar to the following:

You can run a bulk INSERT using a SELECT query in place of a VALUES list.

INSERT INTO [GraphQL].[Users] ([UserLogin]) 
SELECT [UserLogin] FROM [Local_Users] 
You can run a bulk UPATE using a JOIN with a local table.
UPDATE [GraphQL].[Users]  
INNER JOIN [Local_Users] ON [Local_Users].[Id] = [GraphQL].[Users].[Id] 
SET [GraphQL].[Users].[UserLogin].[Local_UserLogin] 
You can run a bulk DELETE using the IN filter with sub-SELECT query.
DELETE FROM [GraphQL].[Users WHERE [Id] IN (SELECT [Id] FROM Local_Users) 

Execute Stored Procedures

To execute the stored procedure, use:
Call CreateJob('Insert')

Copyright (c) 2024 CData Software, Inc. - All rights reserved.
Build 23.0.8839