This section describes how to execute queries using MySQL remoting from any tool that can connect to MySQL.

When executing queries, you use a two-part name format, as shown below,

[<Schema Name (normally but not always the service name)>].[<Table Name>] 

where

• Schema Name is the name of the system schema or user-defined schema.
• Table Name is the name of the table you are copying data from.

SELECT Statements

To create new records:

SELECT * FROM [ActOn].[Images] WHERE FolderName = 'New Folder' 

Note that if the data source supports case-sensitive identifiers, it is not possible to query tables of the same name that only vary by upper or lower case-sensitive (ex: Account and ACCOUNT in the same schema). This is because MySQL treats identifiers as case-insensitive, so multiple tables of the same name in a single schema are fundamentally incompatible with the MySQL protocols.

INSERT, UPDATE, and DELETE Statements

To insert, update, or delete a single row of data (that is, not a batch of records), you need to use the two-part name. For example:

INSERT INTO [ActOn].[Images] (FolderName) VALUES ('New Folder'); 

Bulk Operations

To perform bulk operations, you can use syntax similar to the following:

You can run a bulk INSERT using a SELECT query in place of a VALUES list.

INSERT INTO [ActOn].[Images] ([FolderName]) 
SELECT [FolderName] FROM [Local_Images] 

You can run a bulk UPATE using a JOIN with a local table.

UPDATE [ActOn].[Images]  
INNER JOIN [Local_Images] ON [Local_Images].[Id] = [ActOn].[Images].[Id] 
SET [ActOn].[Images].[FolderName].[Local_FolderName] 

You can run a bulk DELETE using the IN filter with sub-SELECT query.

DELETE FROM [ActOn].[Images WHERE [Id] IN (SELECT [Id] FROM Local_Images) 

Execute Stored Procedures

Use the following to run the stored procedure:

Call CreateJob('Insert')